Badger Meter ORION Classic (CE) - Manual (Page 33)

6 Tap in the Pressure field Then use the keypad to enter the correct pressure factor, if necessary
7 Tap Direction On the Select Meter Direction screen, tap to select clockwise or counter clockwise for the drive gear
Figure 43: change gas pressure factor Figure 44: Select drive gear direction
NOTE: N For a list of meters and the rotation direction of the drive gear, see "gas Meter drive Rotation" on page 76 in
the Appendix
8 Tap the Select button on the Select Gas Drive Circle screen to store the drive circle information you selected
Result: The IR Programming screen displays.
If you made changes to the drive circle, the field is highlighted as shown in Figure 45.
Figure 45: Before programming Figure 46: After programming
9 Align the optical head of the IR cable with the gas endpoint IR LED port and tap Program
Result: The gas endpoint is programmed and the field is no longer highlighted.
NOTE: N With an ORION Migratable gas endpoint, you can also access the Drive Circle information via the
Ext. Status button
ORION IR PROgRAMMINg
Page 33 April 2014 ORION® Endpoint Utility for Trimble® Ranger 3