Badger Meter ORION Classic (CE) - Manual (Page 35)

Start, Pause, Stop - Radio Modes
All ORION Classic endpoints are programmed at the factory to begin sending meter readings as soon as the register senses
flow through the meter As a result, ORION Classic endpoints can be installed on meters without having to manually start the
endpoint When usage is registered on the meter, the endpoint sends a signal every four seconds
The Stop button is used to stop an endpoint from sending a signal, regardless of
the usage registered from the meter Align the optical head on the IR cable with
the endpoint IR LED port and tap Stop The Start button must be used to turn the
endpoint on again
The Pause button is used to pause the radio signal temporarily Align the optical
head on the IR cable with the endpoint IR LED port and tap Pause The endpoint
begins transmitting again when usage is registered from the meter
Figure 48: Radio modes
The Start button is used to start an endpoint after it is stopped or before usage is registered Align the optical head on the IR
cable with the endpoint IR LED port and tap Start
NOTE: N Stopped radios must be restarted using the Start function (above) and will not automatically restart when usage
is registered from the meter When used with an RTR, the odometer value must also be programmed to reflect the
current registration reading See "IR Programming an ORION classic Endpoint (RTR)" on page 36 for more information
When used with an ADE, the odometer value is automatically updated within the hour
ORION IR PROgRAMMINg
Page 35 April 2014 ORION® Endpoint Utility for Trimble® Ranger 3