Badger Meter ORION Classic (CE) - Manual (Page 38)

IR Programming an ORION Classic Gas Endpoint
NOTE: N Before beginning, make sure the IR programming cable is connected and the COM port is set correctly See "Hardware
Settings" on page 63 for additional information
1 From the ORION Endpoint Utility menu, tap ORION IR Programming
2 Align the optical head of the IR cable with the gas endpoint IR LED port Then tap Read
Result: The Select gas drive circle screen is displayed automatically.
Figure 53: IR programming screen with Read Figure 54: Select gas drive circle screen
3 To change the pressure factor, tap in the Pressure
field Use the keypad to change the pressure factor,
if necessary
4 Select the Drive Circle for the gas endpoint
• Use the selections in the top half of the screen
to filter the list on the bottom by choosing
Integral or Remote, and choosing the Units,
Dials and Res (resolution)
• Or just scroll through the list to find the drive
circle for the endpoint
5 Tap the Select button to store the drive circle
Figure 55: gas pressure factor
6. Result: The IR Programming screen is displayed with the
selected drive circle displayed.
Figure 56: gas drive circle
ORION IR PROgRAMMINg
Page 38 April 2014 ORION® Endpoint Utility for Trimble® Ranger 3