Badger Meter ORION Classic (CE) - Manual (Page 27)

High Resolution (HR) E-Series Extended Status
Figure 29: Extended Status - HR E-Series
The status indicators described below apply for an ORION Migratable (or Fixed Network in mobile mode) endpoint when
connected to an HR E-Series meter
Status Indicator Description
EP Prog Endpoint is reporting that it has been reprogrammed via IR
EP Tamper Endpoint is reporting a tamper condition This condition occurs when the wire between the
E-Series meter and the endpoint is cut or shorted, or the encoder is not connected
Mobile Mode Endpoint is communicating in mobile transmission mode
EP Low Battery Endpoint is reporting a low battery condition
Encoder Error E-Series meter is reporting a device error to the endpoint
Empty Pipe E-Series meter is reporting a no flow condition in the pipe
Low Temp E-Series meter indicates the low temperature limits have been exceeded
ENC End of Life E-Series meter is reporting to the endpoint that the encoder battery life indicator has been
activated
No Usage E-Series meter is reporting a no usage condition to the endpoint
Reverse Flow E-Series meter is reporting a reverse flow condition to the endpoint
Leak E-Series meter is reporting a potential leak condition to the endpoint
Sensor Error Endpoint is reporting a sensor error or meter alarm other than empty pipe or low temp
Encoder Information Description
Size & Type The size and type for which the E-Series meter was programmed
Units The units of measure as defined by the E-Series meter: cubic meters, cubic feet, gallons,
imperial gallons or liters
Encoder The encoder protocol
Dials Encoder dial resolution (8) as reported from the E-Series meter
Reverse Flow Total The total reverse flow units measured by the E-Series meter
NOTE: N Refer to the E-Series Installation and Programming manuals, available at www.badgermeter.com , for a detailed list of
encoder status indicators
ORION IR PROgRAMMINg
Page 27 April 2014 ORION® Endpoint Utility for Trimble® Ranger 3