Canon Color imageCLASS MF9280Cdn - Manual (Page 264)

Fax
5-43
Specifying Destinations
Specifying Fax Numbers via an LDAP Server
You can specify e-mail addresses and fax numbers by searching the directory listings on the network using
LDAP (Lightweight Directory Access Protocol) servers. E-mail addresses and fax numbers obtained via the
server can be specified as destinations or stored in the Address Book.
This section describes how to specify fax numbers via an LDAP server.
If <Language Switch> is set to <On>, some characters are restricted and cannot be entered. To enter all characters, set <Language
Switch> to <Off>. (See “Introduction of the Machine,” in the e-Manual.)
You may have to set up the LDAP servers beforehand, depending on the network environment.
If you want to specify or register destinations via an LDAP server, the LDAP server settings must be specified in the machine
beforehand. (See “Network Settings,” in the e-Manual.)
For information on how to specify e-mail addresses via an LDAP server, see “E-mail,” in the e-Manual.
For details on how to send the documents, see “Basic Methods for Sending Faxes,” on p. 5-17. –
–
–
–
–
1
Press (Main Menu).
2
Use [ ▼], [▲] or (Scroll Wheel) to select
<Send/Fax>, then press [OK].
3
Use [ ▼], [▲] or (Scroll Wheel) to select
<Search LDAP Server>, then press [OK].
4
Use [ ▼], [▲] or (Scroll Wheel) to select
the desired server to search, then press
[OK].