Canon Color imageCLASS MF9280Cdn - Manual (Page 487)

12-32
Error Messages
Troubleshooting
Message Description Action
Search condition includes
characters that cannot be used
with the selected server. “\” is used in the search criterion. – Remove “\” from the search criterion,
and then search again. –
The combination of characters
used in the search criterion does
not constitute an acceptable
search criterion.
There is an unequal number of
“(“ and “)”.
“*” is not placed within “( )”.
–
•
•
Make sure that the characters for
the search criterion are combined
properly, and then search again. –
If <Server LDAP Version and Char.
Code> is set to <Ver.2 (JIS)>,
characters other than ASCII Code
(0x20-0x7E) are being used. – Omit characters that cannot be used,
and then search again. –
Set the IP Address. This machine is not set with an IP
address. Specify the IP Address Settings in
<TCP/IP Settings> in <Network Settings>
in <System Management Set> (from
the Additional Functions screen), then
turn the machine’s main power OFF and
back ON again. (See “Network Settings,”
or “Setting Up the Machine,” in the
e-Manual.)
Set the toner cartridge. (XXX) (XXX
indicates either “Black”, “Yellow”,
“Cyan”, or “Magenta”.) The toner cartridge of the indicated
color is not set. Set the toner cartridge of the indicated
color. For detailed instructions, see
“Replacing the Toner Cartridge with a
New One,” on p. 11-8.
The counter has reached the set
value. You cannot print because the set
page limit for either scans, prints,
or copies in the department ID
management function has been
reached. Contact your system manager.
The memory is full. The machine is full of jobs. – Print, send, or delete any documents
stored in memory.
Divide the document stack or data into
a few parts and try again one by one.
Send the document with low
resolution.
When this message appears during
using the feeder, the scanning
document stops halfway. In this case,
clear the paper jam from the feeder. –
–
–
–