Savin 4800WD - Manual (Page 18)

Basics
8
1
Important
❒ The paper capacity indicated assumes the use of standard copier paper, and
should only be used as a guide. If the paper exceeds the upper limit, the cop-
ies may become folded or cause paper jams.
Original Output Locations
The following original output loca-
tions are available:
❖ ❖ ❖ ❖ Top Original Exit
This is the basic original output lo-
cation. Originals are ejected onto
the upper output stacker.
❖ ❖ ❖ ❖ Rear Original Exit (straight)
Originals are ejected onto the orig-
inal output supports. When copy-
ing thick or hard originals, select
this output location.
❖ ❖ ❖ ❖ Rear Original Exit (document roller)
When copying rolled originals
such as long length originals, select
this output location so that origi-
nals can be rolled and stacked by
the document roller. See p.9 “Rear
Original Exit (Document Roller)”.
Note
❒ Originals of 52.3 g/m 2 – 104.7
g/m 2 (13.9 lb – 27.9 lb) can be
used with the document roller.
❒ Do not use the document roller
when copying originals that are
l o n g e r t h a n t h e m a x i m u m
length for each paper type. Use
both hands to roll the original.
Copy output Capacities
Copy Output:
Front Roll paper Plain paper (at normal tem-
perature and humidity): 99 sheets
Plain paper (at high or low
temperature and humidity): 10 sheets (A1 L to A2)
99 sheets (smaller than A2)
Translucent paper(vellum): 10 sheets
Film: 1 sheet
Cut sheet paper Plain paper, and translucent
paper (vellum):
10 sheets
Film: 1 sheet
• Same size copy paper
• Normal temperature = 23 °C
Normal humidity = 65%
Copy Output:
Rear A1 (D) K, A0 (E): 10 sheets (plain paper)
1 sheet (translucent paper)
1 sheet (film)
• Same size copy paper
• When using A0 size copy paper, attach the copy output (rear) auxiliary
guide. See p.11 “Using the rear output to eject A0 (E) KPaper”.
DolphinC2_ENcopy_F_FM.book Page 8 Friday, February 25, 2005 10:46 AM