Savin 4800WD - Manual (Page 77)

67
3. Troubleshooting
If Your Machine Does Not Operate As You
Want
When a Message Appears
The following chart contains explanations of common messages. If other mes-
sages appear, follow the instructions displayed.
Message Problem/Causes Solutions
Please wait. The main power has just been
turned on, paper type (plain
paper/translucent pa-
per/film) was changed, or the
machine is otherwise getting
ready. Wait for the machine to fully
warm-up.
Note
❒ When “
Scanning
originals can be
started. ” and “ Se-
lect copy mode and
Place original ” are
displayed alternately, you
can make the settings for
your copies and scan your
originals. After the origi-
nals have been scanned,
the machine will automati-
cally start copying after it
has warmed-up. See p.23
“Auto Start”.
Check paper size An improper paper size is set. Select paper manually, do not
use Auto Paper Select.
Check original ori-
entation.
In User Auto Reduce/En-
large, the original is set to
L.
For User Auto Reduce/En-
large, set the original to
K.
In User Auto Reduce/En-
large, the original is set to
K.
For User Auto Reduce/En-
large, set the original to
L.
Memory is full. The machine's memory is full
due to scanning originals or
performing a function. The
number of originals that can
be stored in memory depends
on the size of originals and
function settings. • When Sort is selected,
press [Exit] to copy
scanned originals, and
then copy remaining origi-
nals.
• When the Job Preset func-
tion is selected, check the
number of preset jobs, and
then try scanning the orig-
inals again.
DolphinC2_ENcopy_F_FM.book Page 67 Friday, February 25, 2005 10:46 AM