Savin 4800WD - Manual (Page 33)

Basic Procedure
23
2
Auto Start
If you make settings and scan the
originals while the message “
Scan-
ning originals can be started. ”
and “ Select copy mode and press
[Start]. ” are displayed alternately,
your copies will be made once the
machine is ready.
Job Preset
Use this function to set up the next
copy job and scan an original when a
copy job is in progress. When the cur-
rent copy job is finished, your copy
job will start automatically.
Reference
“Job List”, General Settings Guide
AAAA
Press [New Job] while ” Copying... "
is displayed.
BBBB
Make settings for the next copy
job.
CCCC
Place the originals. The machine
scans them.
When the current copy job finish-
es, the preset job starts automati-
cally.
Note
❒ Each job stored is allocated a job
number that is displayed on the
Reserved Job screen.
❒ To switch the display to the cur-
rent copy job press [Reserved
Job]
, followed by [Printing], and
then [Exit].
Editing Job Preset
You can check and change the con-
tents of preset jobs. You also can de-
lete preset jobs.
AAAA
Press [Reserved Job].
BBBB
Select the number of the job you
want to check or change.
CCCC
Press [Check / Change Job].
The contents of the job are dis-
played.
To check the job contents
AAAA
Check the contents of the job.
BBBB
Press [Confirmed].
The display returns to the Re-
served Job screen.
To change the job contents after
checking
AAAA
Check the contents of the job.
BBBB
Change its contents, and then press
[Confirmed]
.
CCCC
Press [Change].
The display returns to the Re-
served Job screen.
DolphinC2_ENcopy_F_FM.book Page 23 Friday, February 25, 2005 10:46 AM