Savin 4800WD - Manual (Page 84)

Troubleshooting
74
3
Copies shift sideways. The paper roll is not set cor-
rectly. Set the paper roll correctly,
making sure it is straight and
not loose. See “
CLoading Pa-
per Roll”, General Settings
Guide.
The original does not match
the size in the original table
setting. Adjust the original guides to
the specified size, and then in-
sert the original along the
guides. See p.15 “Placing
Originals”.
The paper is not set correctly
in the paper bypass. Make sure the paper size
matches the paper bypass's
paper guides. See p.25 “Copy-
ing from the Paper Bypass”.
Copies shift in the direction of
the original feed (or opposite)
direction. Print Position Adjustment or
Margin Adjustment mode is
selected. Cancel Print Position Adjust-
ment or Margin Adjustment
mode. See p.50 “Margin Ad-
justment” and p.61 “Adjust
Print Position”.
Copies are shorter than the se-
lected size, or cut off before
the end.
Wrinkles appear on the copy. The paper is damp. Replace the paper with new
paper.
Cut the paper to 1000 mm
(40") just before copying.
The paper is damp. See “Anti-
humidity Heater Switch”,
General Settings Guide. Turn on the anti-humidity
heater. See “Anti-humidity
Heater Switch”, General Set-
tings Guide.
Copies are slanted. The original is not straight. Insert the original along the
original guides, so it is
straight.
Original and copy size does
not match. Dampness can cause paper to
stretch. Adjust the Fine Magnification
setting for Additional Copy.
See p.41 “Fine Magnification”.
You cannot combine several
functions. The selected functions cannot
be used together. Check the combination of set-
tings, and set again. See p.97
“Combination Chart”.
Problem Causes Solutions
DolphinC2_ENcopy_F_FM.book Page 74 Friday, February 25, 2005 10:46 AM