Savin 4800WD - Manual (Page 26)

Basics
16
1
❒ When inserting long length orig-
inals, there may be some move-
me nt t o e it her side. If thi s
happens, correct the movement
manually while feeding the
originals into the machine.
CCCC
Press the
{{{{#}}}} key after all origi-
nals have been scanned.
- - - -To stop originals feeding in
If the originals are feeding in slanted,
or jamming, etc., press the
{{{{Scanner
Stop
}}}} key to stop them feeding in.
Note
❒ When you press the {{{{Scanner Stop}}}}
key, the original stops immediate-
ly, which can cause it to jam. If this
happens, see “
xClearing Mis-
feeds”, General Settings Guide.
❒ When you have set rear original
exit as the original output location,
the rear edge of the originals are
held at the output exit. To cancel
this, press the
{{{{Scanner Stop}}}} key.
See p.8 “Original Output Loca-
tions”.
Original Orientation
Place the original of the same orienta-
tion as the copy paper on the original
table.
1. Feeding direction
When you cannot place the original
as the above, you may not make cop-
ies as you want with particular func-
tions. If this happens, change the
orientation by selecting [
] or [ ] .
Note
❒ It is recommended that you use
this function together with the
Auto Paper Select or Preset Re-
duce/Enlarge function.
AAAA
Press [Orientation/Custom].
BBBB
Select the original orientation,
and then press [OK].
ZEDH150E
AHD005S
DolphinC2_ENcopy_F_FM.book Page 16 Friday, February 25, 2005 10:46 AM