Savin 4800WD - Manual (Page 44)

Copying
34
2
Sample Copy
Use this function to check the copy
settings before making a long copy
run.
Preparation
Select [Press Start Key] under Feed
Start Method in System Settings.
You cannot make sample copy
when [Auto] is selected. See “Feed
Start Method”, General Settings
Guide.
Note
❒ This function can be used only
when the Sort function is selected.
AAAA
Select [Sort] and make any other
necessary settings, and then place
the originals.
BBBB
Press the
{{{{Sample Copy}}}} key.
One copy set is delivered as a sam-
ple.
CCCC
If the sample is acceptable, press
[Print]
.
The specified number of copies is
made, minus one for the sample
copy.
Note
❒ If you press [Suspend] after
checking the results, return to
step
A to adjust the copy set-
tings as necessary. Depending
on the combination of func-
tions, you may not be able to
change certain settings.
Changing the number of sets
You can change the number of copy
sets during copying.
Note
❒ This function can only be used
when the Sort function is selected.
AAAA
While " Copying... " is displayed,
press the
{{{{Clear/Stop}}}} key.
BBBB
Press [Change Quantity].
CCCC
Enter the number of copy sets us-
ing the number keys, and then
press the
{{{{#}}}} key.
Note
❒ The number of sets you can en-
ter differs depending on when
the
{{{{Clear/Stop}}}} key is pressed.
DDDD
Press [Continue].
Copying starts again.
AHD104S
DolphinC2_ENcopy_F_FM.book Page 34 Friday, February 25, 2005 10:46 AM