Sony COM-1 - Manual (Page 20)

COM-1.US.2-668-393-12(2)
Getting Started…
Preparing a Power Source
20 20
Charging the battery using the supplied USB cable

Connect the supplied USB cable to the  (USB) connector of
the unit, and then connect the USB cable to the computer.
USB cable (supplied)
To  (USB)
connector
The unit automatically turns on. The CHARGE and POWER indicators
light up, and the battery indicator sections (
) appear on the display in
succession as charging progresses.
A complete charge requires approximately 4 hours.
Notes
• The supplied interface cable must be used with the equipment in order to comply with
the limits for a digital device pursuant to Subpart B of Prat 15 of FCC Rules.
• If your unit is connected to your computer via the included USB cable and the computer
enters a power saving mode (such as system suspend, sleep, or hibernation), then your
unit’s battery will begin discharging.
• Do not leave the unit connected for extended periods to a notebook computer that is not
connected to AC power, because the unit may discharge the computer’s battery.
• If the unit does not automatically turn on when you connect it to your computer using
the USB cable, wait a few minutes, and then turn it on by sliding the POWER switch
down ( page 22).
• Connecting the unit via a USB hub may not work and is not supported. Connect the
USB cable directly to the computer.
• Charging may take a long time if you operate the unit while it is charging.
Continued 
Index
Table of
Contents