Balboa Water Group BP 60Hz User Manual
Page 10
10
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417, 834 b2,
Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
4/22/13
General Troubleshooting & Servicing of Spa's Electrical Equipment
DANGER
Risk of electric shock. Before working with any electrical
connections, make certain that the Main Power breaker from
the house breaker box has been turned off.
WARNING
ALL ELECTRICAL WORK MUST BE PERFORMED BY A
QUALIFIED ELECTRICIAN AND MUST CONFORM TO ALL
LOCAL CODES.
IMPORTANT
DUE TO THE DANGER OF SEVERE ELECTRICAL SHOCK,
LOCATE ALL POWER DISCONNECTS BEFORE SERVIC-
ING A SPA. PRECAUTIONS MUST BE TAKEN WHENEVER
WORKING WITH BREAKER BOXES, G.F.C.I.’S, OR SERVICE
DISCONNECTS.
Always refer to the wiring diagram that is included with each
system on the inside of the system box cover. Use this diagram
for voltage measurement points, and for proper reconnection
of wires.
HIGH VOLTAGE CAN SERIOUSLY INJURE OR KILL!
ONLY EXPERIENCED TECHNICIANS SHOULD SERVICE THIS EQUIPMENT.
DO NOT REMOVE THE PROTECTIVE COVERS FROM ANY ELECTRICAL ENCLOSURE, OR ATTEMPT TO SERVICE ANY RELAT-
ED ELECTRICAL DEVICE, UNLESS YOU ARE A QUALIFIED ELECTRICIAN OR SERVICE PROFESSIONAL.
SAFETY TIPS
Keep children and pets away.
UÊ
Be aware of your surroundings. Standing in water while
UÊ
repairing a spa puts you at serious risk.
Avoid working in cramped or crowded conditions.
UÊ
Consider placing a padlock on the service panel to lock
UÊ
out anyone who might power up the system.
A terminal marked “GROUND” is provided
within the System Control Center enclosure.
To reduce the risk of electrical shock, connect
this terminal to the grounding
terminal of the electric supply
panel with a continuous
green insulated copper wire
equivalent in size to the circuit
conductors supplying this
equipment, but no smaller than
#12 AWG.
Ground in System Enclosure