Balboa Water Group BP 60Hz - Manual (Page 64)

64
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417, 834 b2,
Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
4/22/13
DEMO (DEMO MODE)
Demo Mode is not always enabled, so it may not appear. This
is designed to operate several devices in a sequence in order
to demonstrate the various features of a particular hot tub.
INFO (SYSTEM INFORMATION SUB-MENU)
The System Information Menu displays various settings and
identification of the particular system. As each item in the
menu is highlighted, the detail for that item is displayed at the
bottom of the screen.
SSID (SOFTWARE ID)
Displays the software ID number for the System.
MODL (SYSTEM MODEL)
Displays the Model Number of the System.
SETP (CURRENT SETUP)
Displays the currently selected Configuration Setup Number.
SIG (CONFIGURATION SIGNATURE)
Displays the checksum for the system configuration file.
HEATER VOLTAGE (FEATURE NOT USED ON CE
RATED SYSTEMS)
Displays the operating voltage configured for the heater.
HEATER WATTAGE AS CONFIGURED IN SOFTWARE
(CE SYSTEMS ONLY)
Displays a heater kilowatt rating as programmed into the
control system software (1-3 or 3-6).
H _ (HEATER TYPE)
Displays a heater type ID number.
SW _ (DIP SWITCH SETTINGS)
Displays a number that represents the DIP switch positions of
S1 on the main circuit board.
PANL (PANEL VERSION)
Displays a number of the software in the topside control panel.
GFCI (GFCI Test) (Feature not available on CE rated systems.)
GFCI Test is not always enabled, so it may not appear. This
screen allows the GFCI to be tested manually from the panel
and can be used to reset the automatic test feature. If the GFCI
Test Feature is reset, the device will trip within 7 days.
TP400, TP600 Message Codes
The following are messages and features that can appear on the TP400 and TP600 panels.
NOTE: LCD readouts may look slightly different than shown on screen.
MESSAGE CODES
(Found on the pages listed)
M0[XX] numbers are Message Codes 52
M015 59, 66
M016 56, 65
M017 56, 65
M019 65
M019* 52
M020 59, 66
M021 59, 66
M022 59, 66
M026 59, 66
M027 56
M028 56, 65
M029 59, 65
M030 56, 65
M031 66
M031, Sensor A: 59
M032 66
M032, Sensor B: 59
M033 65
M034 59, 66
M035 59, 66
M036 59, 66
M037* 54