Ppp/ethernet – Airlink EDGE/GPRS User Manual
Page 100
PinPoint-E EDGE/GPRS - User Guide, version 2.32
94
AT Commands: PPP/Ethernet
This group includes commands specific to PPP or Ethernet connections between the PinPoint-E
and a connected device.
*HOSTAUTH=n
*HOSTNETMASK=n.n.n.n
*HOSTPEERIP=d.d.d.d
PPP/Ethernet
FIGURE 1.
Common : PPP/Ethernet
Host Authentication Mode:
Use PAP or CHAP to request the user login and password during PPP or
CHAP negotiation on the host connection. The username and password set in *HOSTUID and
*HOSTPW will be used.
n=0 : Disable PAP or CHAP request (Default).
n=1 : PAP and CHAP.
n=2 : CHAP
For PPPoE, set *HOSTAUTH=1 or *HOSTAUTH=2.
Subnet mask for the host interface. Allows communication with a subnet behind the host inter-
face.
n.n.n.n = subnet mask, example 255.255.255.0
Set or query the IP address that can be used to directly contact the PinPoint-E once a EDGE/
GPRS connection is established. If this value is not specified, 192.168.13.31 will be used.
d.d.d.d=local or peer IP of modem
Note: This is not normally used nor needed by user applications.