Airlink EDGE/GPRS - Manual (Page 88)

PinPoint-E EDGE/GPRS - User Guide, version 2.32 82
AT Commands: Serial
S5=n
S6=n
S8=n
S9=n
S10=n
S23=[speed],[databits][parity][stop bits]
Backspace Character
n=0-127 (ASCII character number )
This register sets the character recognized as a backspace during command entry.
Cannot be configured in Wireless Ace.
Wait for Blind Dial
n=2-10 seconds
This register denotes the wait time, in seconds, before a blind dial (no dial tone detection).
Cannot be configured in Wireless Ace.
Comma Pause Time (Dial Modifier)
n=0-255
Whenever a dial command contains the comma character, the contents of this register specify
the pause time for each comma.
Cannot be configured in Wireless Ace.
Carrier Detect Response Time
n=0-255
Specifies the time that the received carrier must be present for the modem to recognize it and
turn on Data Carrier Detect (DCD) if applicable. The implementation is entirely at the IWF
modem.
Cannot be configured in Wireless Ace.
Lost Carrier Hang-up Delay (Remote)
n=1-2545
Specifies the amount of time that the carrier from the remote modem can be lost before the
modem goes on-hook. This allows temporary disruptions to carrier without disconnecting.
A setting of 255 causes the modem to disable Carrier Detect and presume carrier is always
present.
Cannot be configured in Wireless Ace.
Serial line parameters. The settings take affect after reset.