Airlink EDGE/GPRS - Manual (Page 125)

PinPoint-E EDGE/GPRS - User Guide, version 2.32 119
PPPoE: Point to Point Protocol over Ethernet
PPPoE connections can use a Service Name to differentiate PPPoE devices. You can use Wireless
Ace to give your
PinPoint-E a name.
a. In Wireless Ace, select Dynamic IP from the groups on the left.
b. Enter a name for *MODEMNAME, such as PinPoint-E or the ESN .
FIGURE 3. Wireless Ace: *MODENMNAME
a. Click the Write button on the tool bar of Wireless Ace and wait for the message “Write Suc-
cessful” to appear in the status bar.
FIGURE 4. Wireless Ace: Write
FIGURE 5. PinPoint-E Reset Button
The name you choose will not affect the connection but may need to be configured
in PPPoE settings for the router, device or computer you will be connecting to your
PinPoint-E.
4. Write the configured settings to your PinPoint-E.
b. Press the modem Reset button on the front of the modem. Wait until the modem indicator is
lit and the modem has once again registered on the network.
AirLink Modem