Airlink EDGE/GPRS - Manual (Page 122)

PinPoint-E EDGE/GPRS - User Guide, version 2.32 116
AT Commands: EDGE/HSDPA
FIGURE 1. EDGE/HSDPA
*NETAPN=apn
+CGQMIN
+CGQREQ
+COPS=mode,[format][,oper]
EDGE/HSDPA
This group includes commands specific to EDGE and GPRS.
The commands displayed in Wireless Ace and the results of those commands depends on the
model of the modem.
Easy entry of the APN.
apn=access
If left blank, the modem will attempt to use the default subscriber value as defined by the
account.
Minimum Acceptable Quality of Service Profile.
Change should be at carrier's request. Normally not required to be changed.
Set Quality of Service Profile.
Change should be at carrier's request. Normally not required to be changed.
Manually specify an operator. Refer also to *NETOP.
mode=0 : Automatic - any affiliated carrier [default].
mode=1 : Manual - use only the operator <oper> specified.
mode=4 : Manual/Automatic - if manual selection fails, goes to automatic mode.
format=0 : Alphanumeric ("name") (G3310E must use this format).
format=2 : Numeric
oper=”name”