Airlink EDGE/GPRS - Manual (Page 98)

PinPoint-E EDGE/GPRS - User Guide, version 2.32 92
AT Commands: Dynamic IP
This group includes commands specific to dynamic DNS. Dynamic DNS allows the PinPoint-E to
use a dynamic IP (can change each time you connect) account but still allow you to use a fully
qualified domain name to contact the PinPoint-E using IP Manager (page 15) running on a server
with a dynamic DNS updater.
FIGURE 1. Common : Dynamic IP
*DOMAIN=[name]
*IPMANAGERn=[name]
Dynamic IP
Domain (or domain zone) of which the PinPoint-E is a part. This value is used during name
resolutions if a fully qualified name is not provided and also for DNS updates. This value can
be up to 20 characters long.
name = domain name (i.e. eairlink.com)
If *DOMAIN=eairlink.com, then when ATDT@remote1 is entered, the fully qualified name
remote1.eairlink.com will be used to perform a DNS query to resolve the name to an IP
address.
Note: Only letters, numbers, hyphens, and periods can be used in a domain name.
Sets a domain name or IP address to send IP change notifications to. Up to two independent IP
Manager servers can be set, using either AT*IPMANAGER1 or AT*IPMANAGER2. Updates
to a server can be disabled by setting that entry to nothing (for example,
“AT*IPMANAGER1=”).
n=1 : First IP Manager server.
n=2 : Second IP Manager server.
name = domain name