Airlink EDGE/GPRS - Manual (Page 87)

PinPoint-E EDGE/GPRS - User Guide, version 2.32 81
AT Commands: Serial
DS=n
En
Hn
Qn
S3=n
S4=n
Allows a PPP connection to be initiated on the host port.
n=2 : Initiates the PPP connection.
Cannot be configured in Wireless Ace.
Toggle AT command echo mode.
n=0 : Echo Off
n=1 : Echo On
Hang-Up Command.
n=1: Hang-up
With an AT telnet connection, this command will terminate the host data mode and return the
PinPoint-E to an AT mode.
Cannot be configured in Wireless Ace.
The AT quiet-mode setting. If quiet mode is set, there will be no responses to AT commands
except for data queried.
n=0 : Off (Default)
n=1 : Quiet-mode on
Carriage Return Character
n=0-127 (ASCII character number )
The standard end of line character used to indicate the end of an AT command. This character
is also used as the carriage return character for framing responses and result codes in command
state.
Cannot be configured in Wireless Ace.
Line Feed Character
n=0-127 (ASCII character number )
The standard line feed character sent by the modem to the host at the end of a response or
return code in command state.
Cannot be configured in Wireless Ace.