Airlink EDGE/GPRS User Manual
Page 103
PinPoint-E EDGE/GPRS - User Guide, version 2.32
97
AT Commands: PassThru
\APASSTHRU
Caution: This mode is not available through the remote AT telnet server. You will need to
connect to the
PinPoint-E
with it connected directly to your computer.
Sets the modem operation to pass through mode. This mode will pass any characters received
on the Ethernet port directly to the internal hardware module and output any characters from
the internal hardware module out the Ethernet port. This allows direct access/configuration of
the hardware module. Once this mode is entered, the unit must be physically reset to return to
normal operation.
This command is not available in Wireless Ace.
Note: It may take up to 30 seconds for the hardware module to respond after CONNECT is
output.