Airlink EDGE/GPRS - Manual (Page 48)

PinPoint-E EDGE/GPRS - User Guide, version 2.32 42
Global Positioning System (GPS)
If you are sending reports on the local Ethernet port, and/or if you want them sent automatically,
you will need to set *PPLATS. The time interval, just as for *PPTIME, is in seconds.
FIGURE 8. Wireless Ace: Local Automatic Reports
The PinPoint-E can be configured to wait a specific amount of time after initialization before any
reports are sent.
FIGURE 9. Wireless Ace: GPS Initialization Timer
RAP Configuration
RAP has additional features which allow reports based on external physical events, input from a
3rd party devices, store and forward processing, etc.
Most of the configuration settings for RAP can be changed with the RAP configuration command
message. Refer to the AirLink Tracking System User Guide.
RAP Reports Over-The-Air (Remote)
To configure the PinPoint-E to send RAP reports to a remote server, you will need to set 3 com-
mands: *PPIP, *PPPORT, and *PPGPSR.
FIGURE 10. Wireless Ace: RAP Reports Remote
1. Set the IP (*PPIP) and port (*PPPORT) to the IP and port of the server to which you want the
reports sent.
2. Set the GPS Report Type (*PPGPSR) to your preferred RAP report type.
11 - GPS - Global Positioning System data
12 - GPS + Date - GPS data with the UTC time and date
13 - GPS + Date + RF - GPS data with the UTC time and date and Radio Frequency informa-
tion from the antenna.