Using taip command emulation, Taip id, Supported taip commands – Airlink EDGE/GPRS User Manual
Page 58
PinPoint-E EDGE/GPRS - User Guide, version 2.32
52
Global Positioning System (GPS)
1.
Set the port (S53) to 1000. The local IP will automatically be used. S53, in Wireless Ace, is
part of the Misc menu option.
2.
Set ATS Local Report Type (*PPLATSR) to F0 - TAIP Data.
3.
Set the Local ATS Reporting Time Interval (*PPLATS) to 5 to send reports every 5 seconds
(can be adjusted as circumstances warrant).
Using TAIP Command Emulation
To configure the PinPoint-E to use TAIP emulation set GPS Report Type (*PPGSPR) to F0 - TAIP
Data.
FIGURE 30.
Wireless Ace: TAIP Emulation
TAIP ID
The TAIP messages can be configured to send the user specified identification number (ID). This
greatly enhances the functional capability of the unit in a network environment. Set the ID using
*PPTAIPID.
FIGURE 31.
Wireless Ace: TAIP ID
Supported TAIP Commands
The TAIP emulation will accept the following TAIP message types:
SRM (Set Reporting Mode) allows the client to set the reporting mode configuration. The
report mode configuration is not stored in non-volatile memory and such should be resent upon
a unit reset. This behavior emulates that specified in TAIP specifications.
QRM (Query Reporting Mode) reports the reporting mode configuration (returns an “RRM”
message).
SID (Set ID) allows the client to set the TAIP ID (AT*PPTAIPID can also be used to set the
TAIP ID). The TAIP ID, when set with a “SID” message, will be written to non-volatile mem-
ory.
QID (Query ID) reports the TAIP ID (returns an “RID” message).
DPV configures automatic reporting of PV (Position/Velocity) reports based on distance trav-
eled and a maximum time. The delta distance value specified in the message is converted to
hundreds of meters and stored as *PPDIST. The maximum time interval is stored as *PPTIME.
Currently the minimum time and epoch values are ignored.
Note:
With TAIP emulation, the PinPoint-E will listen for TAIP messages on port
21000. RAP will be disabled and no RAP messages or commands will be sent or
received on that port.
F0-TAIP data