Airlink EDGE/GPRS - Manual (Page 116)

PinPoint-E EDGE/GPRS - User Guide, version 2.32 110
AT Commands: PinPoint
#IG=n
*MF=hh
*PGPS=n
*PPCOM1000=n
*PPDEVID=n
*PPDIST=n
Note: If RTS is used as an input, hardware flow control cannot be enabled.
Set or query GPS initialization timer.
n=seconds
Time in seconds to wait for GPS acquisition before transmitting at high rates.
Set or query GPS format, where hh is a hex value; 8E (transmit Latitude/Longitude/Direction/
Velocity/Time in binary) or 8F.
hh=hex value
*MF is support for legacy GPS reports which are rarely used by current tracking
applications.
Send NMEA GPS strings out serial link [n=1]. Similar to ATGPS except that the *PGPS
value can be saved to NVRAM so that it will continue to operate after resets.
n=0 : Disabled
n=1: Send NMEA GPS strings out serial link.
Enables support for extra inputs from a COM1000.
n=0 : Disable
n=1 : Enable
Whether or not the PinPoint-E should include the 64-bit device ID in its GPS reports.
n=0 : Disable ID
n=1 : Enable/display ID
Note: *PPPDEVID MUST be 1 if the modem uses a Dynamic IP.
GPS Report Distance Interval in 100 Meter Units (kilomater). 1 mile is approximately 1600
kilometers.
n=1-65535
n=0 : Disabled