Airlink EDGE/GPRS - Manual (Page 55)

PinPoint-E EDGE/GPRS - User Guide, version 2.32 49
Global Positioning System (GPS)
FIGURE 23. HyperTerminal: NMEA Stream
FIGURE 24. Wireless Ace: NMEA Strings
NMEA Messages Over-The-Air (Remote)
To configure the PinPoint-E to send NMEA reports to a remote server, you will need to set 3 com-
mands: *PPIP, *PPPORT, and *PPGPSR.
FIGURE 25. Wireless Ace: NMEA Remote Reports
1. Set the IP (*PPIP) and port (*PPPORT) to the IP and port of the server to which you want the
reports sent.
2. Set the GPS Report Type (*PPGPSR) to your preferred NMEA sentence format.
E0 - Output the GGA and VTG sentences.
E1 - Output the GGA, RMC, and VTG sentences.
NMEA Messages over a Local Connection (PPP)
To stop the stream, with either terminal connection, use the command ATGPS0 (this can be
entered even while data is streaming). You can also use AT*PGPS=1 then AT&W to allow you
to stream the data even after the modem is reset.
You can also issue this command using Wireless Ace to stream the data from the serial port with-
out using HyperTerminal or another terminal application. The data will stream even after the
modem is reset.
Local reports are sent to the local IP address of the computer or device connected to the serial port
of the PinPoint-E. To configure the modem to send to the local IP, you will need to set 3 com-
mands: *S53, *PPLATS, and *PPLATSR.
1000
E0-NMEA GGA+VTG