Hale CAFS Attack - Manual (Page 24)

❑ Receiving and Inspection
24 CAFS Air Bottle Installer/Operation Guide
p/n: 029-0020-85-0
❑ Appropriate air injection hose, 1/4” (6 mm), up 6,000 PSI (414 BAR)
❑ Appropriate discharge hose or piping, 1/4” (6 mm), up ??? PSI (???
BAR)
❑ Appropriate electrical wire, Type SXL, GXL or TXL
❑ Appropriate DOT air injection tube, 3/8” (9.5 mm)
❑ Appropriate LOW pressure drain and HIGH pressure tubing / hose, rec-
ommended - 3/8” (10 mm), up 6,000 PSI (414 BAR)
Unpacking
The CAFSAttack system is shipped partially assembled on two skids. One
skid contains the CAFSAttack air bottle cylinder module assembly. The
second skid contains the FoamLogix Pump Unit along with all supplied
loose items.
Use care when removing the CAFSAttack from its packaging (skid) to pre-
vent injury and/or damage to the system, especially the external system
connections.
IMPORTANT!
EXERCISE CARE DURING UNPACKING AND INSTALLATION TO ENSURE
THAT THE IDENTIFICATION TAGS ARE NOT REMOVED BEFORE THE CON-
NECTIONS ARE MADE.
DO NOT REMOVE OR ALTER ANY HYDRAULIC OR PNEUMATIC CONNEC-
TIONS WITHOUT WRITTEN APPROVAL FROM CLASS1. ALSO REVIEW SEC-
TION 1 “SAFETY PRECAUTIONS” BEGINNING ON PAGE 7.
Lifting The System
WARNING!
THE CAFSATTACK AIR BOTTLE (H-CYLINDER TYPE) ASSEMBLY IS HEAVY
AND BULKY, WEIGHING OVER 500 LBS. (227 KGS.). SEE BILL OF LADING
FOR ACTUAL WEIGHT. USE PROPER LIFTING SUPPORT DEVICES (OVER-
HEAD CRANE, STRAPS/CHAINS, ETC.) CAPABLE OF HANDLING THE LOAD
WHEN MOVING OR INSTALLING THE SYSTEM. ATTACH LIFTING APPARA-
TUS TO THE CYLINDER FRAME ONLY. DO NOT ATTACH STRAPS AROUND
THE CYLINDERS, ESPECIALLY THE SHUT-OFF VALVE AREA. ALSO SEE
FIGURE 4-2: “DOT AIR BOTTLE CYLINDER ASSEMBLY LAYOUT DIMEN-
SIONS” ON PAGE 26.