Hale CAFS Attack - Manual (Page 39)

39 CAFS Air Bottle Installer/Operation Guide
p/n: 029-0020-85-0
In s talle r In sta llatio n
❑
CAUTION !
❑ Review the “Safety” section of this manual, beginning on page 7, in
its entirety before proceeding with electrical connections.
❑ To prevent system damage or electrical shock the main power sup-
ply wire must be the last connection made.
❑ The cables provided with each CAFSAttack system contain
shielded assemblies.
NEVER attempt to shorten or lengthen these shielded cables.
If necessary order longer or shorter cables from Class1 to suit your
particular installation.
❑ The cables are indexed so they connect to the correct receptacle
one way only. The cables shipped with each CAFSAttack system
are tested at the factory with the specific unit. When making cable
connections DO NOT force mismatched connections as damage
can result, causing improper system operation.
❑ The system can only perform when the electrical connections are
sound.
Make sure each electrical connection is correct.
❑ Class1 CAFSAttack systems are designed for use on direct current,
negative (–) ground apparatus electrical systems only.
❑ Do not mount a radio transmitter or transmitter cables in direct or
close contact with the CAFSAttack unit.
❑ Before connecting cables, inspect the O-ring seal in the female con-
nector. If the seal washer is missing or damaged, water can enter
causing corrosion, resulting in possible system failure.
❑ Be careful when inserting connector halves to avoid bent pins or
pushed-back pins that do not make contact.
❑ The ground strap must be attached to the chassis frame. Ground-
ing to the body IS NOT acceptable.
❑ Always disconnect the power cable, ground straps, electrical wires
and cables from the control unit or other Hale FoamLogix equip-
ment before electric arc welding at any point on the apparatus.
Failure to do so could result in a power surge through the unit that
could cause irreparable damage.
❑ There are no user serviceable parts inside CAFSAttack system
electrical/electronic components. Opening of these components
(motor distribution box, smart-switch controller or control unit)
voids the warranty.