Hale CAFS Attack - Manual (Page 98)

INSTALLATION
Inspect the regulator, valve, and
accessories for physical damage and
contamination. Do not connect the
regulator, valve, or accessory if you detect
oil, grease, or damaged parts. If the
regulator, valve, or accessory is damaged,
contact your local Tescom representative to
have the regulator cleaned or repaired.
Make sure that the components
and materials used in the fluid
handling system are compatible
with the fluid and have the
proper pressure rating.
REPAIR SERVICE
If a regulator or valve leaks or malfunctions,
take it out of service immediately. You must
have instructions before doing any
maintenance. Do not make any repairs you
do not understand. Have qualified
personnel make repairs. Return any
equipment in need of service to your
equipment supplier for evaluation and
prompt service. Equipment is restored to
the original factory performance
specifications, if repairable. There are flat
fee repair charges for each standard model.
The original equipment warranty applies
after a complete overhaul.
Safe Component Selection
1. Consider the total system design when
selecting a component to ensure safe,
trouble-free performance.
2. The user is responsible for assuring all
safety and warning requirements of the
application are met through his/her own
analysis and testing.
5 6
Safe Component Selection
(continued)
3. Tescom may suggest material for use
with specific media upon request.
Suggestions are based on technical
compatibility resources through
associations and manufacturers.
Tescom does NOT guarantee materials
to be compatible with specific media --
THIS IS THE RESPONSIBILITY OF
THE USER!
4. Component function, adequate ratings,
proper installation, operation, and
maintenance are the responsibilities of
the system user.
Do not modify equipment or
add attachments not approved
by the manufacturer.
ASSEMBLY/INSTALLATION DRAWINGS
& BILLS OF MATERIAL Drawings and
parts lists for your product may be
obtained by calling the number below.
Tescom will provide these by fax or mail.
Your local Tescom representative can
provide additional assistance.
Call (800) 447 - 1250
for assembly/installation drawings &
bills of material. Be sure to have your
complete model number ready.
Form No. 1891 Rev. 5/00 Printed 5/04 80M
INDUSTRIAL CONTROLS DIVISION
12616 Industrial Boulevard
Elk River, MN 55330
WARNING
WARNING
WARNING
WARNING
4
SAFETY PRECAUTIONS
(Continued):
construct vent lines to prevent conden-
sation or gas accumulation. Make sure
the vent outlet is not obstructed by rain,
snow, ice, vegetation, insects, birds, etc.
Do not interconnect vent lines; use
separate lines if more than one vent is
needed.
20. Do not locate regulators, valves, or
accessories using flammable fluids near
open flames or any other source of
ignition.
21. Some fluids when burning do not exhibit
a visible flame. Use extreme caution
when inspecting and/or servicing
systems using flammable fluids to avoid
death or serious injury to employees.
Provide a device to warn employees of
these dangerous conditions.
22. Many gases can cause suffocation.
Make certain the area is well ventilated.
Provide a device to warn employees of
lack of oxygen.
23. Never use oil or grease on these
regulators, valves, or accessories. Oil
and grease are easily ignited and may
combine violently with some fluids under
pressure.
24. Have emergency equipment in the area
if toxic or flammable fluids are used.
25. Upstream filters are recommended for
use with all fluids.
26. Do not bleed system by loosening
fittings.
27. Prevent icing of the equipment by
removing excess moisture from the gas.
28. Always use proper thread lubricants and
sealants on tapered pipe threads.
WARNING