BNC 645 - Manual (Page 30)

30
Output button becomes lit when output is enabled.
Remote Interface Operation
OUTPut {OFF|ON}
Notes
• The Output is automatically disabled when an excessive external
voltage is applied to the Output connector on the front panel and
an error will be generated and the error message will be shown.
Remove the overload from the Output connector and enable the
Output again.
3.12 To Enabled/Disable Sync Out Signal
All the standard output functions, except dc and noise, can be associated
with a sync-out signal. It is outputted at the Sync connector on the front
panel.
Front-panel Operation
• To enable/disable the sync out signal, press the Utility button, and
then the Sync softkey to toggle the setting.
Figure 3-12
Figure 3-13
Remote Interface Operation
OUTPut:SYNC {OFF|ON}