BNC 645 - Manual (Page 75)

75
for storing a user-defined instrument state. The location “0” can only be
accessed from the remote interface. Although you may store an
instrument state in it, it is always preserved for power-down state.
Anything previously stored in it will be overwritten with the power-down
state when the waveform generator is turned off.
Although you may assign a custom name to any of these locations from
the remote interface, you cannot assign a name for location “0” from the
front panel. The name can contains up to 12 characters, but the first
character has to be a letter and the rest of them can be numbers, letters
or the underscore character (“_”).
How to store/recall the instrument state
1. Press the Store/Recall button to enter the instrument state
submenu.
Figure 4-19
2. To store an instrument state, press the softkey under Store State
to enter the store-state submenu:
a. Press the softkey under your desired location number to
choose the location (only 1 to 4 are available from front
panel operation).
b. You may specify a name for the selected memory location.
Use the numeric keypad and the knob with the cursor keys
for entry.
c. Press the Store State softkey to store the present setting in
the memory or the Cancel softkey to cancel.
Figure 4-20