BNC 645 - Manual (Page 84)

84
under Cancel to withdraw the changes.
8. Press the DONE softkey to return to the LAN submenu.
DNS Setup Submenu
9. Press the softkey under DNS Setup to enter the submenu.
10. Host Name
a. Press the softkey under Host Name to set the host name for
your waveform generator.
b. Use the numeric keys and the knob with the arrow keys to
enter your desired letters or symbols.
11. Domain Name
a. Press the softkey under Domain Name.
b. Use the numeric keys and the knob with the arrow keys to
enter your desired letters or symbols.
12. DNS Server
a. Press the softkey under DNS Serv.
b. Use the numeric keys to enter the IP address of the DNS
server.
c. Press the softkey under Enter to finish the entry or the softkey
under Cancel to withdraw the changes.
13. Press the DONE softkey to return to the LAN submenu.
View Current Configuration
14. Press the softkey under Current Conf to display the current LAN
configuration.
6.2 Remote Interface Commands
You may instruct your Model 645 waveform generator to output
waveforms using the SCPI (Standard Commands for Programmable
Instrument) commands after the selected remote interface is
appropriately set up. This section lists the SCPI commands available for
remotely controlling the waveform generator. For first time SCPI users,
refer to Appendix B for the introductory materials on SCPI commands.
Note that the following conventions are used in SCPI command syntax.
The triangle brackets, <>, indicate that you must specify a value for the
enclosed parameter. The square brackets, [], indicate that the