BNC 645 - Manual (Page 68)

68
DIGital:PATTern:FREQuency {<frequency>, MINimum, MAXimum}
Set the frequency of the pattern, 1uHz ~ 50MHz.
DIGital:PATTern:FREQuency? {MINimum, MAXimum}
Inquire and gain the minimum or maximum frequency of the pattern.
DIGital:PATTern:STARt {<address>, MINimum, MAXimum}
Set the start address (min. 1) of the pattern.
DIGital:PATTern:STARt? {MINimum, MAXimum}
Inquire and gain the start address of the pattern.
DIGital:PATTern:STOP {<address>, MINimum, MAXimum}
Set the end address of the pattern.
DIGital:PATTern:STOP? {MINimum, MAXimum}
Inquire and gain the end address of the pattern.
DIGital:PATTern:REPeat {ON, OFF}
Set the pattern repeat again, yes (ON) or no (OFF).
DIGital:PATTern:REPeat?
Inquire and gain the pattern out status, repeated or not.
DIGital:PATTern:CLOCk {POS, NEG}
Set the latching data clock of the pattern to be a positive (rising) edge or
a negative (falling) edge.
DIGital:PATTern:CLOCk?
Inquire and gain the latch data clock status of the pattern in positive
(rising) or negative (falling) edge.
DIGital:PATTern:TRIGger:SOURce {EXT, BUS}
Set the trigger source of the pattern, such as from EXT or BUS. (Please
note that there is no IMM internal trigger.
DIGital:PATTern:TRIGger:SOURce?
Inquire and gain the trigger source of the pattern.