BNC 645 - Manual (Page 83)

83
name into IP address. The DNS server address is the IP address of the server
that provides this service. The setting is stored in non-volatile memory, so it
is not affected by power cycle or the remoter interface reset command.
How to set up LAN interface
1. Press the Utility button and then the softkey under I/O.
2. Press the softkey under LAN to enter the LAN submenu. You have
the options to set up IP address and related parameters (under
the IP Setup softkey), DNS configuration (under the DNS Setup
softkey) or to view the current LAN configuration (under the
Current Config softkey).
IP Setup Submenu
3. Press IP Setup softkey to enter the submenu.
4. DHCP
a. Press the softkey under DHCP to toggle between DHCP OFF
and DHCP ON.
b. With DHCP OFF, you need to enter IP address, subnet mask
and default gateway as the steps shown below. With DHCP ON,
all these settings will be automatically obtained from the DHCP
server.
5. IP Address
a. If DHCP is off, press the softkey under IP Addr to set an IP
address.
b. Use only the numeric keys to enter an IP address.
c. Press the softkey under Enter to finish the entry or the softkey
under Cancel to withdraw the changes.
6. Subnet Mask
a. If DHCP is off, press the softkey under SubMask to set subnet
mask.
b. Use only the numeric keys to enter the value.
c. Press the softkey under Enter to finish the entry or the softkey
under Cancel to withdraw the changes.
7. Default Gateway
a. If DHCP is off, press the softkey under Def Gate to set up the IP
address of the default gateway.
b. Use only the numeric keys to enter the value.
c. Press the softkey under Enter to finish the entry or the softkey