ElmoMC AC Input Digital Servo Drives-Tuba - Manual (Page 21)

Tuba Installation Guide Installation
MAN-TUBIG (Ver. 1.502)
www.elmomc.com
21
3.3.2. Mounting on a DIN Rail
At the top rear of the Tuba, a horizontal groove lets you quickly and easily snap the drive onto a
DIN rail in your work area.
To mount the Tuba on a DIN rail:
1. Be sure that the vertical mounting strip (with the hole at the top) is pressed down fully and
does not protrude from the top of the instrument.
Figure 4: Mounting Strip Pressed Down
2. Tilt the Tuba back towards the top part of the DIN rail.
Figure 5: Attaching Top Part of Mounting Groove to a DIN Rail