ElmoMC AC Input Digital Servo Drives-Tuba - Manual (Page 43)

Tuba Installation Guide Installation
MAN-TUBIG (Ver. 1.502)
www.elmomc.com
43
3.4.7.2. Differential Auxiliary Encoder Input Option on FEEDBACK B (YA[4]=2)
The Tuba can be used as a slave by receiving the position of the master encoder data (on Port
B1) in Follower or ECAM mode. In this mode Port B2 provides differential buffered auxiliary
outputs for the next slave axis in follower or ECAM mode.
Below are the signals on the Auxiliary Feedback port when set up to run as a differential
auxiliary encoder input:
Port Pin Signal Function Pin Positions
B1 1 INDEX Auxiliary Index high input
COR016A
15-Pin D-Sub Socket
B1 2 CHB Auxiliary Channel B high input
B1 3 CHA Auxiliary Channel A high input
PWR 4 +5V Encoder supply voltage
PWR 5 SUPRET Encoder Supply return
B2 6 CHAO Buffered Channel A output
B2 7 CHBO Buffered Channel B output
B2 8 INDEXO Buffered Index output
B1 9 INDEX- Auxiliary Index low input
8
15
1
9
Port B1 Power
Port B2
15-Pin D-Sub Plug
on Tuba
B1 10 CHB- Auxiliary Channel B low input
B1 11 CHA- Auxiliary Channel A low input
PWR 12 SUPRET Supply return
B2 13 CHAO- Buffered Channel A complement output
B2 14 CHBO- Buffered Channel B complement output
B2 15 INDEXO- Buffered Index complement output
Table 7: Differential Auxiliary Encoder Input Option on FEEDBACK B
Pin Assignments
FEEDBACK B on the front of the Tuba has a 15-pin D-Sub plug. Connect the Auxiliary Feedback
cable from the feedback device to FEEDBACK B using a 15-pin D-Sub socket with a metal
housing. When assembling the Auxiliary Feedback cable, follow the instructions in Section 3.4.4
(Feedback and Control Cable Assemblies).