ElmoMC AC Input Digital Servo Drives-Tuba - Manual (Page 59)

Tuba Installation Guide Installation
MAN-TUBIG (Ver. 1.502)
www.elmomc.com
59
3.5. Powering Up
After the Tuba has been mounted, check that the cables are intact. The Tuba servo drive is then
ready to be powered up.
Caution:
Before applying power, ensure that the AC supply is within the range specified
for your specific type of Tuba.
3.6. Initializing the System
After the Tuba has been connected and mounted, the system must be set up and initialized.
This is accomplished using the Composer, Elmo’s Windows-based software application. Install
the application and then perform setup and initialization according to the directions in the
Composer Software Manual.