Lenze E94AxHE Technology Application Table positioning - Manual (Page 10)

9400 Technology applications | Table positioning
Introduction
10
L
EDS94TA10050xxxx EN 1.2 - 03/2010
3 Introduction
Positioning means to move a workpiece/tool or a piece of material from a starting
position n to a defined targeto.
For this purpose a travel profile is to be provided in the controller, for which at least the
following profile parameters are required:
 A positioning can consist of several profiles which are executed in a specified mode.
Symbol Profile parameters
Position
Target position or path distance to be traversed.
Speed
Maximum speed with which the target is to be approached.
Acceleration
Selection of the change in speed by which acceleration is to be carried out maximally.
Deceleration
Selection of the change in speed by means of which deceleration to standstill is to be maximally effected
again.
Œ 
v [m/s]
t [s]
A
B
C D
A
B
C
D