9400 technology applications | table positioning – Lenze E94AxHE Technology Application Table positioning User Manual
Page 23
EDS94TA10050xxxx EN 1.2 - 03/2010
L
23
9400 Technology applications | Table positioning
Parameter setting & configuration
Profile data management
7 Speed
Continuous constant travel.
• Only possible with "unlimited" and "limited" traversing range
• This mode does not approach a defined position, but follows the profile.
• Acceleration and deceleration are based on profile values.
• The traversing direction is defined by the sign of the traversing speed.
• Stopped through break signal.
8 Speed TP
Like mode 7, but with profile change on touch probe detection.
11 Absolute CW
The axis travels in CW direction to an absolute position.
• Only possible with "Modulo" traversing range.
• Reference for the absolute position is zero position.
• In this direction the zero position of the axis can be overtravelled.
12 Absolute CW TP
Like mode 11, but with profile change on touch probe detection.
13 Absolute CCW
The axis travels in CCW direction to an absolute position.
• Only possible with "Modulo" traversing range.
• Reference for the absolute position is zero position.
• In this direction the zero position of the axis can be overtravelled.
14 Absolute CCW TP
Like mode 13, but with profile change when a touch probe is detected.
15 Absolute ShortestWay
The axis travels to an absolute position in best time.
• Only possible with "Modulo" traversing range.
• Reference for the absolute position is zero position.
• The rotary table positioning is basically an absolute positioning with target positions between 0 and 360
angular degree [°]. In this mode the zero point can also be overtravelled if this is the shortest way to the
target position:
16 Absolute ShortestWay TP
Like mode 15, but with profile change on touch probe detection.
Positioning mode
360°/0°
60°
120°
300°
240°
180°