SATEC PM175 Manual - Manual (Page 132)

‎Chapter 4 PAS Application Software Viewing Recorded Files
132 Series PM175 Powermeters
Selecting Waveform Channels
To select the channels you want to view on the screen, click
on the waveform window with the right mouse button, select
“Channels...”, check the channels you want displayed, and
then click OK.
Using the Marker Lines
Waveform and RMS panes have two blue dashed marker
lines. The left marker indicates the position from where data is
taken to calculate the harmonics spectrum and phasor
diagrams, and as the starting position for calculating the RMS,
average and peak values. The right marker indicates the end
position for calculating the RMS, average and peak values.
The minimum distance between the two markers is exactly
one cycle.
To change the marker position, click on the button, or click
on the waveform window with the right mouse button and
select Set Marker, and then click on the point where you want
to put the marker. You can drag both markers with the mouse,
or use the right and left arrow keys on your keyboard to
change the marker position. Click on the waveform pane to
allow the keyboard to get your input before using the
keyboard.
Delta Measurements
To measure the distance between two waveform points, click
on the Delta button
, then click on one point, and then click
on the second point. The first reference point is still frozen until
you close and reopen Delta, while the second point can be
placed anywhere within the waveform line. You can measure a
delta in both directions. To disable the Delta, click on the Delta
button once again.