Rockwell Automation 20D PowerFlex 700S Drive Ph I Control, Frames 1...11 - Manual (Page 16)

1-2 Installation/Wiring
Opening the Cover
Mounting Clearances
Esc
7 8 9
4 5 6
1 2 3
. 0 +/-
Sel
Jog
Alt
Exp Param #
S.M.A.R.T. Exit Lang Auto / Man Remove
DRIVE DRIVE
SYNCHLINK ENABLE
Opening Control Assembly
Step Description
Loosen captive screw.
Push down on cover.
Pull cover away from assembly.
A
B
C
A
B
C
Frames 1-4
Locate the slot in the upper left corner.
Slide the locking tab up and swing the
cover open. Special hinges allow cover to
move away from drive and lay on top of
adjacent drive (if present). See
page 1-8
for frame 4 access panel removal.
Frame 5
Slide the locking tab up, loosen the
right-hand cover screw and remove. See
page 1-8 for access panel removal.
Frame 6
Loosen 2 screws at bottom of drive cover.
Carefully slide bottom cover down and
out. Loosen the 2 screws at top of cover
and remove.
Frames 1-6
101.6mm
(4.0 in.)
101.6mm
(4.0 in.)
101.6mm
(4.0 in.)
101.6mm
(4.0 in.)
50.8mm (2.0 in)
50.8mm (2.0 in)
Refer to the PowerFlex Reference
Manual Vol. 2 for detailed
dimension information
With Adhesive Label
(see below)
No Adhesive Label
(see below)
Frames 1-6