Rockwell Automation 20D PowerFlex 700S Drive Ph I Control, Frames 1...11 - Manual (Page 53)

Start-Up 2-3
Assisted Start-Up This routine prompts you for information needed to start-up a drive for most
applications, such as line and motor data, commonly adjusted parameters
and I/O.
The assisted start-up routine asks simple yes or no questions and prompts
you to input required information. Access Assisted Start-Up by selecting
“Start-Up” from the Main Menu.
Important: This start-up routine requires a HIM. If the drive is configured for 2-wire
control, the HIM installed on the drive will also act as a 2-wire device. In
2-wire mode, the drive will start when the HIM “Start” is pressed and
stop when the HIM “Start” is released. The recommended mode of use
for the Start-Up Routine is 3-wire control, Parameter 153 [Control
Options], Bit 8 set to “1”.
Step Key(s) Example LCD Displays
1. To exit the User Display screen, Press Esc.
1. In the Main Menu, use the Down Arrow to scroll to
“Start Up”
2. Press Enter.
TIP: Throughout the Start-Up Routine many screens
have more selection than shown. Use the arrow keys
to scroll through all the menu options.
1. Follow the instructions on the screen to complete
the Start-Up.
Esc
Auto F Stopped
RPM
DC Bus V
Output C
0.0
0.0
0.0
Auto F Stopped
0.0
RPM
Main Menu:
Parameter
Device Select
Diagnostics
0.0
0.0
routine sets up
Diagnostics
PowerFlex 700S
Start-Up
The Start-Up
the drive for
basic operation.
Push Enter.
Important: If using a HIM the following functions are not available.
• Alt-Man
• Alt-Lang
• Alt-SMART