Rockwell Automation 20D PowerFlex 700S Drive Ph I Control, Frames 1...11 - Manual (Page 236)

H-2 PowerFlex 700S Multi-Device Interface Option Card
Supported Rotary Encoders
Table H.A specifies which encoders work with the MDI Option.
Important: Please note that encoders must be ordered as "Single Ended".
This will ensure that the RS-485 channel has the proper
termination network installed at the factory.
Table H.A Supported Stegmann Rotary Encoders
SINCOS®, SINCODER ® and LINCODER ® are registered trademarks of Stegmann Inc.
Recommended Cables
Model Resolution Comment
SINCOS® SCS-60, SCS-70,
SCM-60, and SCM-70 512 sine cycles per revolution. SCM-60 and SCM-70 have built-in
mechanical turns counter.
SINCOS® SCS-KIT-101 and
SCM-KIT-101 1024 sine cycles per revolution. SCM-60 and SCM-70 have built-in
mechanical turns counter.
SINCOS® SRS-50, SRS-60,
SRM-50, and SRM-60 1024 sine cycles per revolution. SRM-50 and SRM-60 have built-in
mechanical turns counter.
SINCOS® SRS/M 25 1024 sine cycles per revolution SRS25 and SRM25 have built-in
mechanical turns counter. IP65
Protection Class. Size 25 square
flange mounting.
SINCOS® SRS660 1024 sine cycles per revolution Hollow-shaft up to 14 mm diameter
SINCOS® SHS-170 512 sine cycles per revolution. While the software supports this
encoder, the SHS-170 draws
excessive current and should only be
used with an external power supply.
If you are using this motor and feedback
device:
Use this cable:
Temposonics III Linear sensors with MTS part
numbers ending in 1S2G1102 Mating MTS molded extension cable for RG connector or integral P
cable
Allen-Bradley 1326AB-BXXXX-21ML, and
-21MKXL motors with embedded Stegmann
rotary encoder Allen-Bradley 1326-CECU-XXL-XXX
Allen-Bradley 1326AB-BXXXX-M2L, -M2KXL,
-S2L, and -S2KXL motors with embedded
Stegmann rotary encoder Allen-Bradley 2090-CDNFDMP-SXX
Any other motor with external Stegmann
SRS/SRM25 rotary encoder Stegmann 6-411562-XX cables with 10-Pin MS connector assembly
6-430080-00
Any other motor with other external Stegmann
rotary encoders Stegmann 6-411682-XX cables with C12 FUR connectors
Important: Please note that encoders must be
ordered with the C12 FUR connectors
to accommodate these cables.