Grounding -6, Sensitive circuits -6, Te (true earth) termination -6 – Rockwell Automation 1336R REGEN LINE REG User Manual
Page 22: Pe (power earth) termination -6, 480vac power wiring, D frame, Figure 2.3 — regenerative dc bus supply grounding, 2–6 regenerative dc bus supply operation
2–6
Regenerative DC Bus Supply Operation
380-480VAC Power
Wiring
Grounding
All 1336 REGEN components must be connected to system
ground at the PE power ground terminal provided. Ground
impedance must conform to the requirements of national and local
industrial safety regulations (NEC, VDE 0160, BSI, etc.), and
should be inspected and tested at appropriate intervals. In any
cabinet, a single low-impedance ground point or ground bus bar
should be used. All circuits should be grounded independently and
directly. The AC supply ground conductor should also be
connected directly to this ground point or bus bar.
Figure 2.3 — Regenerative DC Bus Supply Grounding
Sensitive Circuits
It is essential to define paths
through which high frequency
ground currents flow to ensure that
sensitive circuits do not share a
path with these currents. Control
and signal conductors should not
be run near or parallel to power
conductors.
TE (True Earth) Termination
The converter’s TE terminals are
used for all control signal shields
internal to the 1336 REGEN
Converter and must be connected
to the converter’s TE terminals by
a separate continuous lead.
PE (Power Earth) Termination
A safety ground is required by
code. This point must be
connected to adjacent building
steel or a floor ground rod
provided grounding points comply
with NEC and local regulations.
PE
GND
GND
Conduit/4-Wire Cable
Nearest
Building Structure Steel
PE
GND
GND
PE
PE
PE
COMMON BUS
DRIVE
COMMON BUS
DRIVE
USER
SUPPLIED
120V AC
1336 REGEN
Converter
1321 10%
Line Reactor
1336 REGEN
Precharge
Power
Line Filter
PE
1
(2) jumpers connect PE and TE at the 1336 REGEN
Converter Main Terminal Block. Consult
Allen-Bradley Application Engineering prior
to removing either jumper.
S2
TORQUE TERM. TO 6 N-m (52 lb-in)
T2
USE 75
°
C COPPER WIRE ONLY
R2
DC–
DC+
TE
PE
PE
120
RT
N
120
VA
C
1
1
PE
1
PE TE
R
S
T
TB1-1
TB1-3
R1
S1
T1
R1
S1
T1
R2
S2
T2
R2
S2
T2
+DC
+DC
–DC
–DC
PE
+DC
–DC
120V AC
120 RTN
R
IN
S
IN
T
IN
R
OUT
S
OUT
T
OUT
D Frame