Rockwell Automation 1336R REGEN LINE REG - Manual (Page 53)

Chapter
3
Regenerative Brake
Operation
Overview The 1336 REGEN Line Regeneration Package represents an amp
rated package that can remove energy from the DC bus of a 1336
PLUS, PLUS
II , FORCE or IMPACT AC drive and send it back to
the utility. When properly sized with one or more standard 1336
PLUS, PLUS
II , FORCE or IMPACT AC drives, Regenerative
Brake Operation provides an energy efficient alternative solution
to dynamic braking.
General Precautions
!
ATTENTION: Only personnel familiar with the 1336
REGEN Line Regeneration Package and associated
equipment should plan or implement the installation,
start-up and subsequent maintenance of the system.
Failure to comply may result in personal injury and/or
equipment damage.
!
ATTENTION: This product and its associated
equipment contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static control
precautions are required when installing, testing,
servicing or repairing this assembly. Component
damage may result if ESD control procedures are not
followed. If you are not familiar with static control
procedures, reference publication 8000-4.5.2
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.
!
ATTENTION: The 1336 REGEN Line Regeneration
Package is shipped from the factory with Parameter 1
set to the Regenerative Brake Mode of operation.
Ensure that Parameter 1
[Operational Mode] is set to its
factory setting of Regenerative Brake Mode as
described in the Programming section of this chapter.
Incorrectly applied or installed equipment can result in
component damage or a reduction in product life.
Wiring or application errors, such as incorrect or
inadequate AC supply or excessive ambient
temperatures may result in malfunction of the 1336
REGEN Line Regeneration Package.