Rockwell Automation 1336R REGEN LINE REG - Manual (Page 85)

Regenerative Brake Operation 3–33
Programming Overview
The 1336 REGEN Package is designed so that factory default
parameter settings allow it to operate satisfactorily under a wide
variety of load and utility conditions.
For the majority of applications there should be no need to adjust
parameters. Should utility or load conditions deviate from the
“normal” conditions listed in the Specifications, the following
parameters have been provided to allow adjustments to factory set-
tings.
Important: The 1336 REGEN Package has been shipped from
the factory with Parameter 1 set to the Regenerative
Brake Mode of operation.
Conventions
• Only parameters that are used in the Regenerative Brake mode of
operation are listed in this chapter.
• Some parameters can be modified when the 1336 REGEN
Converter is enabled. Other parameters can be modified only
when the 1336 REGEN is not enabled.
• Parameter Names appear in the display in the left column. If
mentioned in text, they will be shown in [brackets] .
• The Parameter No. is a unique number assigned to each of the 1336
REGEN Package parameters.
• The Display Units are units shown on the HIM — Bits, Amps,
Volts, Percentages or Numbers.
• The Parameter Type heading indicates whether or not the parameter
is read/write or read only. If read/write, whether or not it can be
changed while the converter is enabled.
• The Factory Default value is the value set at the factory. In most
circumstances this value should be sufficient for the application.
• The Min/Max Value is the lowest/highest setting for the parameter.
• Drive Units are internal units used to scale values properly when
reading or writing to the converter.