Rockwell Automation 1336R REGEN LINE REG - Manual (Page 50)

2–34 Regenerative DC Bus Supply Operation
Programming
Parameter No. 23
Display Units Bits
Parameter Type Read/Write
Factory Default 111
Min/Max Value 0/7
Drive Units N/A
Port Enabled Mask
This parameter sets the ability of a SCANport device to issue enable commands. The
commands are defined by the first (3) bits of a 16 bit word. The [Port Enable Mask] may be set
while the 1336 REGEN Converter is enabled.
Bit 0 = 1 When Bit 0 = 1, the system will be set to the auto-enable mode.
Bit 0 = 0 When Bit 0 = 0, this input requires an enable command from SCANport 1 or 2.
Parameter No. 24
Display Units Bits
Parameter Type Read Only
Factory Default N/A
Min/Max Value N/A
Drive Units N/A
Start/Stop Owner
This parameter displays which adapter is currently issuing a valid enable command. Only the
first (3) bits of each byte are valid.
Parameter No. 25
Display Units Bits
Parameter Type Read Only
Factory Default N/A
Min/Max Value N/A
Drive Units N/A
Current Command Being Issued
This parameter displays the logic command currently being issued.
Parameter No. 26
Display Units Bits
Parameter Type Read Only
Factory Default N/A
Min/Max Value N/A
Drive Units N/A
Logic Status
This parameter displays the current logic status of the 1336 REGEN Converter.
n a b l e M a s k E o r t P
1 1 2 3 1 X X X X X
Bit 2 Bit 1 Bit 0
0 = Autoenable Not Allowed 1 = Autoenable Allowed
0 = SCANport 1 Enable Not Allowed 1 = SCANport 1 Enable Allowed
0 = SCANport 2 Enable Not Allowed 1 = SCANport 2 Enable Allowed
t o p O w n e r S t a r t S
0
0
0
1
2 4 0
0
0
0
0
0
0
0
0
0
0
0
Bit 2 Bit 1 Bit 0
0 = Digital Input Enable Present 1 = Digital Input Enable Not
Present
0 = SCANport 1 Stop Not Present
1 = SCANport 1 Stop Present
Bit 10 Bit 9 Bit 8
0 = Digital Input Enable Not Present 1 = Digital Input Enable
Present
0 = SCANport 1 Start Not Present
1 = SCANport 1 Start Present
d S t a t u s n o m m a C
0 1 2 5 0 0 0 0 0 0
Bit3 Bit 1 Bit 0
0 = Stop Command Inactive 1 = Stop Command Active
0 = Enable Command Inactive 1 = Enable Command Active
0 = Clear Fault Command Inactive 1 = Clear Fault Command
0 = Reset Command Not Present 1 = Reset Command Presen
Bit15
S t a t u s o g i c L
0 0 2 6 0 0 0 0 0 0
Bit 1 Bit 0
0 = Converter Not Ready 1 = Converter Ready
0 = Converter Not Enabled 1 = Converter Enabled
0 = Converter Not Faulted 1 = Converter Faulted
Bit 7