Rockwell Automation 1336-GM6 Enhanced DeviceNet Communications Module - Manual (Page 27)

Installation 2-7
Electrostatic Discharge Precautions
Please read the following safety precaution carefully before installing
the 1336-GM6 communications board.
Installing the 1336-GM6 Communications Board
The following instructions explain how to physically install an
Enhanced DeviceNet 1336-GM6 communications board.
Important: If you are attaching the communications board to a 1336
PLUS II, refer to the one-page insert included with the kit for
mounting instructions.
Important: To prevent damage to the board, you must wear a
grounding wrist strap when handling the 1336-GM6 communications
board.
1. Make sure you’ve turned off the power supply to the SCANport
product and DeviceNet network and verified the drive is not
receiving power.
!
ATTENTION: The 1336-GM6 communications
board contains ESD (Electrostatic Discharge) sensitive
parts. Static control precautions are required when
installing, testing, or servicing this board. Device
malfunction may occur if you do not follow ESD control
procedures. If you are not familiar with static control
procedures, refer to Allen-Bradley Publication
8000-4.5.2, Guarding Against Electrostatic Damage, or
other applicable ESD protection handbook.
!
ATTENTION: Remove all power from the SCANport
product before installing the 1336-GM6 board. Failure
to disconnect power may result in death or serious injury.
Verify all power is removed before installing the
1336-GM6 board.