Rockwell Automation 1336-GM6 Enhanced DeviceNet Communications Module - Manual (Page 53)

Configuring the Enhanced DeviceNet Adapter Using RSNetWorx for DeviceNet 4-5
Accessing and Editing Parameters Parameters in the SCANport product and adapter can be edited with
RSNetWorx. The adapter parameters are appended to the list of
product parameters. In Figure 4.8, for example, the drive has 323
parameters, so parameter 324 is the first adapter parameter.
1. After creating an EDS file, right-click on the icon for the
SCANport product and adapter and select Properties. The
Device Edit dialog box appears.
2. Click the Device Parameters tab. If an EDS Editor message
appears, click Upload to load the parameter values in the product
to the computer.
Figure 4.8 Device Parameters Page in the Edit Dialog Box
Parameters are displayed in numerical order under Parameter.
Parameters for the DeviceNet adapter are appended to the end of
the parameter list for the SCANport product. You can either scroll
through the list or select a specific group of parameters in the
Groups box (for example, DeviceNet Module). The available
groups and the numbers of the adapter parameters will vary based
on the type of product that is connected to the adapter.
3. In the Current Value column, double-click a value to edit it.