Rockwell Automation 1336-GM6 Enhanced DeviceNet Communications Module - Manual (Page 98)

B-10 Enhanced DeviceNet Adapter’s Parameters
Enhanced DeviceNet Adapter
Parameters The following table provides information on the Enhanced DeviceNet
communications adapter’s parameter set.
Important: When accessing this parameter set through the
DeviceNet Parameter Class, add the adapter’s parameter number
to the number of the last parameter of the SCANport device. When
accessing this parameter set through the vendor-specific SCANport
Variables-Linear Class, add the adapter’s parameter number to
4000H.
# Name
Valid Values/
Settings
Default Writable
Reset or
Power Cycle
Description
1 SCANport
Adapter
0-7 NA No No Identifies the port number to-which the adapter
is connected on the SCANport product.
2 DN Node Address 0-63 63 Yes Yes Identifies the DeviceNet Node Address for the
adapter.
3 DN Data Rate 125K
250K
500K
Auto
Auto Yes Yes Identifies the data rate used on the DeviceNet
network.
Important: At least one node on your
DeviceNet network must be configured to a
data rate (125, 250, or 500 K), not autobaud.
4 Cmd/Stat Config Off, On On Yes Yes Determines whether to pass logic command and
analog reference control data from a DeviceNet
connection to a SCANport product. If you are
using a Master (scanner), parameters 24 and 25
must also be set.
5 Datalink A Cfg Off, On Off Yes Yes Determines whether to pass control data
contained in datalink A from a DeviceNet
connection to the SCANport product. If you are
using a Master (scanner), parameters 24 and 25
must also be set.
6 Datalink B Cfg Off, On Off Yes Yes Determines whether to pass control data
contained in datalink B from a DeviceNet
connection to the SCANport product. If you are
using a Master (scanner), parameters 24 and 25
must also be set.
7 Datalink C Cfg Off, On Off Yes Yes Determines whether to pass control data
contained in datalink C from a DeviceNet
connection to the SCANport product. If you are
using a Master (scanner), parameters 24 and 25
must also be set.
8 Datalink D Cfg Off, On Off Yes Yes Determines whether to pass control data
contained in datalink D from a DeviceNet
connection to the SCANport product. If you are
using a Master (scanner), parameters 24 and 25
must also be set.
Important: For information on accessing and editing parameters, refer to Chapter 3, Configuring the 1203-GU6 Using a Serial
Connection, or Chapter 4, Configuring the 1203-GU6 or 1336-GM6 Adapter Using RSNetWorx for DeviceNet.